cable length
英 [ˈkeɪbl leŋθ]
美 [ˈkeɪbl leŋθ]
链（英国608英尺，美国720英尺）；电缆长度；线长；电线长度
英英释义
noun
- a nautical unit of depth
双语例句
- According to the mechanic characteristics of this system, the bearing cable, the stress-free cable length of carry cable and the meticulous algorithm of suspension force of each span are given, and the influence of gentle cable elongation on its dead weight is presented.
文中根据该系统的力学特点，给出了承重索、轨索的无应力索长和各跨吊杆力的精细算法，并计入了柔索伸长对其自重集度的影响。 - Place the units in their intended mounting locations to check the cable length and monitor installation conditions.
把设备放入计划好的安装位置，检查电缆长度和监视器安装条件。 - However, the issue of measuring precision in the wire and cable market becomes more and more prominent. It is significant to measure the cable length precisely, rapidly and economically.
然而，目前电线电缆市场上存在的计量问题日臻突出，如何准确、迅速、经济的实现对电缆长度的测量，具有重要的理论意义和研究价值。 - Under the conditions of given initial mid-span deflection, the cable length increment and load increment were obtained by means of the mid-span deflection increment.
在给定初始跨中挠度的条件下，利用跨中挠度增量值求得索长增量值与载荷增量值； - The results of simulation and engineering applications indicate that the wavelet de-noising processing with the decomposition level determined by the adaptive selection algorithm can effectively filter out the noise from the TDR signal and then improve the measuring accuracy of the TDR cable length measurement system.
仿真结果和工程应用结果表明，采用该方法确定的小波分解层数对被测信号进行消噪处理，可以有效的滤除信号中的噪声，提高时域反射电缆测长系统的测量精度。 - The principle error of the TDR cable length measurement has also been analyzed. The influence of measuring numbers, counting pulse frequency and traveling wave velocity on measuring accuracy is analyzed.
分析了时域反射电缆测长的原理误差，研究了测量次数、计数脉冲频率、行波波速对测量精度的影响。 - In case the welding machine cannot be placed close to the welding area, enough cable length for both, the welding cable as well as the earth clamp has to be provided.
如果焊机不能置于靠近焊接区，必须提供足够长度的焊接线以及接地夹。 - Meanwhile, a decision method for determine an unknown cable length also recommend.
同时本文还向大家介绍一下未知电缆长度的电缆长度的简易判定方法。 - In this paper, to avoid the current-contact measurement of the drawbacks, a laser Doppler Effect based on the non-contact cable length measurement is used.
本文针对现行接触式测量所存在的弊端，采用了一种基于激光多普勒效应的非接触式电缆长度测量方法。 - Starting from the pre-stressed state, the tension force was calculated by controlling the initial cable length.
从预应力状态开始，通过控制索原长来追踪索在施工中的张拉力。